# a comment at the very top
# should be treated as the file header

# up to the first section, including all blank lines

[section_1]
option_1: value_1
option_1_1: True # this is a boolean
option_1_2: 5 ; this is an integer
option_1_3: 1.123 #;this is a float

[section_2] ; comment
option_2: value_2

; comment

[section_3]
option_3: value_3 # comment

[section_4]
# comment
option_4: value_4

[section number 5]
#option_5: value_5
option_5 = this.is.value-5
multi_option:
  # these are multi-line values
  value_5_1
  value_5_2 ; here is a comment
  value_5_3
option_5_1: value_5_1

[gcode_macro M117]
rename_existing: M117.1
gcode:
  {% if rawparams %}
    {% set escaped_msg = rawparams.split(';', 1)[0].split('\x23', 1)[0]|replace('"', '\\"') %}
    SET_DISPLAY_TEXT MSG="{escaped_msg}"
    RESPOND TYPE=command MSG="{escaped_msg}"
  {% else %}
    SET_DISPLAY_TEXT
  {% endif %}

# SDCard 'looping' (aka Marlin M808 commands) support
#
# Support SDCard looping
[sdcard_loop]
[gcode_macro M486]
gcode:
  # Parameters known to M486 are as follows:
  #   [C<flag>] Cancel the current object
  #   [P<index>] Cancel the object with the given index
  #   [S<index>] Set the index of the current object.
  #       If the object with the given index has been canceled, this will cause
  #       the firmware to skip to the next object. The value -1 is used to
  #       indicate something that isn’t an object and shouldn’t be skipped.
  #   [T<count>] Reset the state and set the number of objects
  #   [U<index>] Un-cancel the object with the given index. This command will be
  #       ignored if the object has already been skipped

  {% if 'exclude_object' not in printer %}
    {action_raise_error("[exclude_object] is not enabled")}
  {% endif %}

  {% if 'T' in params %}
    EXCLUDE_OBJECT RESET=1

    {% for i in range(params.T | int) %}
      EXCLUDE_OBJECT_DEFINE NAME={i}
    {% endfor %}
  {% endif %}

  {% if 'C' in params %}
    EXCLUDE_OBJECT CURRENT=1
  {% endif %}

  {% if 'P' in params %}
    EXCLUDE_OBJECT NAME={params.P}
  {% endif %}

  {% if 'S' in params %}
    {% if params.S == '-1' %}
      {% if printer.exclude_object.current_object %}
        EXCLUDE_OBJECT_END NAME={printer.exclude_object.current_object}
      {% endif %}
    {% else %}
      EXCLUDE_OBJECT_START NAME={params.S}
    {% endif %}
  {% endif %}

  {% if 'U' in params %}
    EXCLUDE_OBJECT RESET=1 NAME={params.U}
  {% endif %}