From ee5c6fc95320d98f026d79a5da48179bb8f651a6 Mon Sep 17 00:00:00 2001 From: Yurii Date: Fri, 17 Nov 2023 22:14:45 +0300 Subject: [PATCH] upd readme, bump version --- README.md | 12 +++++++++++- platformio.ini | 2 +- src/defines.h | 2 +- 3 files changed, 13 insertions(+), 3 deletions(-) diff --git a/README.md b/README.md index e26ccd9..20276be 100644 --- a/README.md +++ b/README.md @@ -89,7 +89,7 @@ The outdoor temperature sensor must be connected to the **TEMP1** connector, the 5. Set up a connection to your MQTT server: ip, port, user, password 6. Set up a **Opentherm pin IN** & **Opentherm pin OUT**. No change for my board. Typically used **IN** = 4, **OUT** = 5 7. Set up a **Outdoor sensor pin** & **Indoor sensor pin**. No change for my board. -8. if necessary, set up a the master member ID ([see more](#tested-on)) +8. if necessary, set up a the Master Member ID ([see more](#tested-on)) 9. Restart module (required after changing OT pins and/or sensors pins!) After connecting to your wifi network, you can go to the setup page at the address that ESP8266 received. @@ -165,6 +165,16 @@ If your boiler does not support the installation of an outdoor temperature senso After these settings, you can enable the "Equitherm" and/or "PID" modes and configure them as described below. +## Troubleshooting +**Q:** Controller in monitor/readon mode (cannot set temperature, etc.)
+**A:** Try changing the "Master Member ID", this is most likely the problem. If you don't know which identifier is valid for your boiler, you need to use brute force. + +**Q:** The boiler does not respond to setting the heating temperature.
+**A:** Try checking the "Opentherm summer/winter mode", "Opentherm CH2 enabled", "Opentherm heating CH1 to CH2" checkboxes one by one and all together on the "setup" page. If this doesn't work, see above. + +**Q:** My boiler does not have a hot water heating function. How to turn it off?
+**A:** Uncheck "Opentherm DHW present" on the "setup" page. + ## About modes ### Equitherm diff --git a/platformio.ini b/platformio.ini index 25922f1..ec8eda3 100644 --- a/platformio.ini +++ b/platformio.ini @@ -25,7 +25,7 @@ lib_deps = build_flags = -D PIO_FRAMEWORK_ARDUINO_LWIP2_HIGHER_BANDWIDTH -mtext-section-literals upload_speed = 921600 monitor_speed = 115200 -version = 1.3.3 +version = 1.3.4 ; Defaults [esp8266_defaults] diff --git a/src/defines.h b/src/defines.h index 90df5f7..3ede21b 100644 --- a/src/defines.h +++ b/src/defines.h @@ -1,4 +1,4 @@ -#define OT_GATEWAY_VERSION "1.3.3" +#define OT_GATEWAY_VERSION "1.3.4" #define OT_GATEWAY_REPO "https://github.com/Laxilef/OTGateway" #define AP_SSID "OpenTherm Gateway" #define AP_PASSWORD "otgateway123456"