Added linuxcnc test config before video release

linuxcnc/sim.gmoccapy.lathe_configs/core_sim_lathe.hal

@@ -0,0 +1,35 @@
+# core HAL config file for simulation
+
+# first load all the RT modules that will be needed
+# kinematics
+loadrt [KINS]KINEMATICS
+# motion controller, get name and thread periods from ini file
+loadrt [EMCMOT]EMCMOT base_period_nsec=[EMCMOT]BASE_PERIOD servo_period_nsec=[EMCMOT]SERVO_PERIOD num_joints=[KINS]JOINTS
+loadusr -W lcec_conf ethercat-conf.xml
+loadrt lcec
+addf lcec.read-all servo-thread
+# add motion controller functions to servo thread
+addf motion-command-handler servo-thread
+addf motion-controller servo-thread
+
+# create HAL signals for position commands from motion module
+# loop position commands back to motion module feedback
+net Xpos joint.0.motor-pos-cmd => joint.0.motor-pos-fb
+net Zpos joint.1.motor-pos-cmd => joint.1.motor-pos-fb
+net Xpos lcec.0.0.commanded-position
+net myXvel lcec.0.0.commanded-velocity joint.0.vel-cmd
+
+# estop loopback
+net estop-loop iocontrol.0.user-enable-out iocontrol.0.emc-enable-in
+
+# create signals for tool loading loopback
+net tool-prep-loop iocontrol.0.tool-prepare iocontrol.0.tool-prepared
+net tool-change-loop iocontrol.0.tool-change iocontrol.0.tool-changed
+
+net spindle-fwd spindle.0.forward
+net spindle-rev spindle.0.reverse
+#net spindle-speed spindle.0.speed-out
+
+net lube iocontrol.0.lube
+net flood iocontrol.0.coolant-flood
+net mist iocontrol.0.coolant-mist